Page History

...

Back to Table of Contents

Back to Installing SBC 5000 and 7000 Series Software

...

The BMC web application allows provisioning of primary and secondary host management interfaces. When the host management interfaces are configured, a direct link from BMC is enabled to EMA for installing and upgrading the

...

1. Login to SBC BMC using the IP address configured in the previous section. At the prompt, enter:
   Username: root
   Password: superuser
   
   The SBC BMC main screen appears.

   Caption
   0 Figure 1 BMC Main Screen
   Image Modified

   
   
   

2. Click Configuration tab. The Configuration screen displays.

   Caption
   0 Figure 1 Configuration Screen

3. From Options menu, click Platform Management Network. A warning message appears.

   Caption
   0 Figure 1 Warning Message

4. Click OK. The Platform Management Network Settings screen displays.
   
   

5. Configure the following network settings for both the Management Interface 0 and 1.
   - IPv4 Address or/and IPv6 Address
   - Prefix
   - Default Gateway
   
   

6. Click Save.

   Caption
   0 Figure 1 Platform Management Network Settings

   Note
   When upgrading from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address. This mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC.

   Note
   If you update the Management IP address through BMC and click Save, you must reinstall the SBC application software. If you update the management IP using CLI, EMS or EMA, it is automatically updated in the BMC and re-installation is not required.

   Caption
   0 Figure 1 Warning Message

   
   
   

...