Page History

...

At this stage, the existing configuration is completely erased. Configure the application as per your needs. Refer to How to Set up a Basic Call Flow to start with you fresh configuration.

2x1 Gbps To 4x1 Gbps Media Interface Upgrade Procedure

This section explains the procedures to upgrade the media interfaces in SBC 5400.

Pre-requisites

1. SBC 5400 should be running on 05.01.00R000 or higher version.
2. Procure the required media interface licenses. Refer to SBC 5400 Media Ports and Operational Modes to know the all the media interface licenses.
3. Access to original and all the subsequent licenses. Refer to SBC 5400 Interface Modes and Media Port Assignments table for the required licenses.
4. Save all your current configuration. Refer to Saving the SBC Configuration to know about how to save your existing SBC configuration. If you wish to return to 1 Gbps interface mode of operation, you can use the saved configuration. The 1 Gbps configuration cannot be applied/imported to 10 Gbps interface mode.

Procedure

The following procedure is applicable only when you upgrade from 2x1 Gbps to 4x1 Gbps interface mode.

1. Log on to SBC 5400 BMC GUI using the credentials: username: root and password: superuser.

   Caption
   0 Figure 1 SBC 5400 Login window
   Image Added

2. Navigate to Configuration > Platform Management Network. The Platform Management Network Settings screen is displayed.

   If you are using 2x1 Gbps speed as your current configuration, only two management ports are used.

   Caption
   0 Figure 1 Media Interface with 2x1 Gbps Speed
   Image Added

3. Add the details for Management Interfaces 2 and 3 (similar to this image).

   Caption
   0 Figure 1 Media Interface with 4x1 Gbps Speed
   Image Added

4. Click Save.

   Note
   A warning message appears stating that the changes made to the management interfaces will be applied only after the application is re-installed.

   Caption
   0 Figure 1 SBC 5400 Media Interface Change Warning Message
   Image Added

5. Click OK to proceed.
   A success message is displayed stating that the network configuration is successfully set.

   Caption
   0 Figure 1 SBC 5400 Media Interface Change Success Message
   Image Added

6. Click OK to proceed.
   All the four management ports are now configured with its IPv4 and default gateway parameters.

   Caption
   0 Figure 1 SBC 5400 Platform Management with 4x1 Gbps Speed
   Image Added

   
   At this point the changes made to the Management Interfaces are not applied to SBC Application. Re-install the SBC application for this changes to get implemented.

7. Once the SBC comes up, log on to the application using the default credentials admin/admin. Change you password immediately to proceed further. Refer to EMA Mode - Login Window to know more about application login credentials.

8. Navigate to Monitoring > Dashboard > System Status. The System Status window is displayed. Under the Server Status panel, the Pkt Port Speed column provides the speed of the media interface port.

   Note
   For 2x1 Gbps and 4x1 Gbps media interface modes, SBC EMA only displays the Pkt Port Speed (Speed 1 Gbps) but does not mention if it is a 2x1 Gbps or 4x1 Gbps media interface mode. It is displayed only in the BMC Platform Management Network Settings screen (step 2 of this procedure).

   Caption
   0 Figure 1 SBC 5400 Pkt Port Status for 4x1 Gbps Speed
   Image Added