Versions Compared

Old Version 4

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH2sbsarkar
AUTH1pmuthu
REV5bscoggins
REV6bscoggins
REV3rasahoo
REV1tasveren

Panel

In this Section:

Table of Contents

Info
titleNote

This object is visible and configurable only for SBC SWe Cloud. Refer to Configuring an SBC SWe Cluster using the EMS for information on configuring SWe Cloud deployments.

The SBC SWe Cloud supports configuring a Load Balancing Service (LBS) to distribute cluster information between D-SBC instances. 

To configure an LBS on a PKT port (any IP Interface other than MGMT), set "clusterAdmin clusterComm type ip" before the LBS configuration on an M-SBC. Refer to Intra-Cluster VNFC Communication Through Packet Ports.

Configuring Load Balance Service

On the navigation pane:

  1. click All > System > Load Balancing Service.

    Caption
    0Figure
    1Load Balancing Service - M-SBC

    Caption
    0Figure
    1Load Balancing Service - S-SBC

  2. Use the table to edit the configurations and click Save.

Parameter Descriptions

Caption
0Table
1Parameter Descriptions
ParameterDescription
Group NameDomain name of the load balancing group.
Private IP Interface Group NameThe name of the Private IP Interface Group used by an M-SBC or T-SBC to communicate with the MRF.

Invite Retarget Mode

Specifies the load balancing service mode for INVITEs. Enables load balancing for initial INVITE requests. 

If set to redirect, calls may get retargeted using SIP 302 to balance the load.

  • Disabled (default)
  • Redirect

Register Retarget Mode

Specifies the load balancing service mode for REGISTERs. Enables load balancing for REGISTER requests.

If set to redirect, new registrations may get retargeted using a SIP 302 message to balance the load.

  • Disabled (default)
  • Redirect

Pagebreak