Page History

Add_workflow_for_techpubs

AUTH1 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'} JIRAIDAUTH CHOR-742 REV5 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'} REV6 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'} REV3 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ce320b29, userName='null'} REV1 UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cc7d083d, userName='null'}

 

Panel
In this section: Table of Contents maxLevel 3

...

Warning
The Administrative IP interface should only be used for Running Initial Setup and disconnected when not in use (especially to avoid conflicts with your network). This interface cannot be used for VOIP media or protocols.

...

In the default software, Ethernet 1 IP is enabled and an IPv4 IP address is acquired via a connected DHCP server. This IP address is used for performing Initial Setup on the

Spacevars
0 series3

. See Running Initial Setup for more information. The default IP address for the logical interface named Ethernet 2 IP is 192.168.129.2. After initial configuration, you may configure this logical interface using Settings or Tasks tabs in the WebUI.

...

If the logical interface is part of a redundant Ethernet pair, several of the options on the secondary logical interface will become read-only. 

Caption

0	Figure
1	Logical Interfaces

Image Removed 

Pagebreak