Page History
| Section | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Panel | ||||||||||||||||
Table of Contents
|
...
Prerequisite
| Tip |
|---|
Assumes the user is familiar with navigating the SBCx000's WebUI |
...
| Panel | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
|
| Pagebreak |
|---|
Configuration Steps
The Lync Wizard Task
...
| Panel | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
|
| Pagebreak |
|---|
Configure Media for TCP/RTP
...
| Panel | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
|
Media Configuration Steps
...
| Tip |
|---|
The fully-sized diagrams in this article are available by download at the bottom of the page |
| Pagebreak |
|---|
Call Routing Configuration
...
| Panel | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
|
ISDN to SIP Call Configuration Steps
- Create a translation table/entry to perform any necessary number translations.
- Use the automatically created ISDN to SIP Call Routing Table, or create a new one of your own. In the Call Routing Table, create a Call Route entry. Configure the translation table name to perform any desired number translations.
- Configure the Egress SG as shown above, setting the Destination Type and Destination Signaling Groups as shown in the diagram.
- Enable transcoding.
In the Inbound ISDN SG: - Verify/Set the Call Route Table and incoming ISDN port
| Pagebreak |
|---|
Configure SIP to ISDN Call Routing
...
| Panel | |||||||
|---|---|---|---|---|---|---|---|
| |||||||
|
SIP to ISDN Call Configuration Steps
...
| Info |
|---|
| Pagebreak |
|---|
Overview
Content Tools