Page History

Available_since
Type Available Since Release 6.1.2

Add_workflow_for_techpubs
AUTH1 JIRAIDAUTH symCHOR-233031199 REV5 REV6 REV3 REV1

 

Note
For SWe Lite Music On Hold, refer to Configuring SBC SWe Lite for Music On Hold.

 This article explains setting up  Spacevars0product to use the Music-on-Hold feature.

 

...

System and Music File Requirements

• Spacevars
  0 product

  must  must be running version 2.1 or later.
• Music files must be one of the following formats:
  • WAV
  • PCMA
  • PCMU
  • PCM

 

Caption
0 Table 1 Maximum File Size
Platform Platform Maximum File Size Spacevars 0 series 1MB1 MiB Spacevars 0 series2 4MB4 MiB

 

Providing

...

the Audio Source

To upload a music (sound) file:

Upload the file using the the Uploading a Sound File procedure in SBC Edge -  procedure in Uploading Music on Hold Files - SBC Edge.

To connect a live audio source through an FXS port:

Specify the live audio source using the the Specifying a Live Audio Source procedure in  procedure in Configuring the Media System.

Connecting an audio source for Music On Hold requires the use of an adapter between

Spacevars
0 product

RJ11  RJ11 port and the source device (CD player, radio, iPod. MP3 player, personal computer, etc.). Common adapters include a 3.5mm connector on one end and an RJ11 on the other with an isolation transformer between the two.

Music On Hold volume is controlled from the audio source device (iPod, MP3 Player, etc.). The preferred volume level can be adjusted by listening to the stream, or by examining the RTP trace captured from the SIP call leg of the call. Use the the receive gain settings  settings on the FXS port to make any additional fine-tuning volume adjustments.

Selecting the Music

...

On Hold Mode

 Enable Music on Hold as follows:

1. From the the Music on Hold drop  drop down list (via applicable applicable SIP Signaling group)select  select Enables for 2-Way Hold only or  only or Always Enabled.
2. Click Click Apply.

Verifying Music Upload Status and FXS Music

...

On Hold source.

To verify that the file has been successfully uploaded:

1. In the WebUI, click

   the

   the Settings

   tab

    tab.

2. In the left navigation pane, go

   to

   to System > DSPs.

The Music on Hold status File Status will be show as Loaded if  if the file was successfully uploaded.

...

Info
Under certain conditions, after multiple, consecutive attended transfers, Music On Hold will not be heard on the SIP phone when the call is put on hold.

...