Page History

...

1. From the Create Signaling Group drop down box at the top of the Signaling Group Table, select CAS Signaling Group.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create CAS Signaling Group Image Modified

   Anchor
   properties properties

CAS Signaling - Field Definitions

...

Line Type

...

• Call Forwarding is automatically disabled.
• The Call Forwarding Feature field is hidden.

...

...

The Call Forwarding feature enables a phone connected to an FXS port to forward incoming calls to another configured telephone number. The SBC supports unconditional call forward on an individual port basis. Call Forward is activated/deactivated on a port with configured specific service codes, accompanied by the forward number. Once the user enters the configured keycode and forward telephone number, all outgoing calls to the port will then be redirected to the forwarding number. When the outgoing call routes to a port that is forwarded, the phone on that port generates a short ring.

In North America, the NANP defines *72<forward number> for activation and *73 for deactivation, but the SBC enables you to configure any 6 character combination for activation and/or deactivation. The SBC enables a keycode to have a minimum length of 3 characters and a maximum of 6; this is based on what is commonly used today.

...

Activate through a Telephone

Activate through a Telephone

The Call Forward feature can be initiated with the following steps:

• Lift the handset to the port (in which calls will be forwarded) and enter the activate keycode + forwarded number, followed by the '#' key on the telephone.
• A confirmation tone (fast beep) indicates a successful Call Forward. A congestion tone (busy tone) indicates call forward failed.
• An activation at the physical phone level automatically activates the feature for the applicable channel in the Assigned Channels table. See Assigned Channels - Field Definitions.

Deactivate through a Telephone

• Lift the handset connected to the port in which calls are being forwarded (that requires deactivation) and enter the deactivate keycode.
• A confirmation tone (fast beep) indicates a successful Call Forward deactivation. A congestion tone (busy tone) indicates call forward has not been deactivated.

...

...

Activate on a Channel through the Channel Table

The Call Forward feature can be activated for a specific channel through the Assigned Channels table as follows:

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups.
3. Click the expand (

...

1. Image Added) icon next to the entry you wish to modify.
2. At the Assigned Channels table, click on the

...

1. Image Added icon.
2. From Channel Selection Method, select Single Port.
3. From Call Forward Activated, select Yes.
4. In Call Forwarding Number box, enter the number to which the call will be forwarded.
5. Click Apply.

Deactivate on a Channel through Channel Table

The Call Forward feature can be deactivated for a specific channel through the Assigned Channels table as follows:

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups.
3. Click the expand (

...

1. Image Added) icon next to the entry you wish to modify.
2. In the Assigned Channels table, click on the (

...

1. Image Added) icon next to the entry in which you want to deactivate Call Forward.
2. From Call Forward Activated, select Disable.
3. Click Apply.

Call Forwarding Activate DTMF

...