Page History

This operation allows you to load new software into the Recovery partition of the ASM. There are a number of reasons why you would want to do this:

...

1. Insert the prepared flash drive into one of the ASM USB ports of the Sonus SBC 1000/2000 system.

   • Updating the ASM Recovery Partition on the Sonus SBC 2000- directly plug it into the USB Port for the ASM.

     Expand
     Click here to see where the ASM USB port is on the front of the Sonus SBC 2000 chassis Click here to see where the ASM USB port is on the front of the Sonus SBC 2000 chassis
     Include Page Sonus SBC 2000 Front Panel Sonus SBC 2000 Front Panel nopanel true

   • Updating the ASM Recovery Partition on the Sonus SBC 1000- directly plug it into the USB Port for the ASM.

     Expand
     Click here to see where the ASM USB port is on the front of the Sonus SBC 1000 chassis Click here to see where the ASM USB port is on the front of the Sonus SBC 1000 chassis
     Include Page Sonus SBC 1000 Front Panel Sonus SBC 1000 Front Panel nopanel true

2. In the WebUI, click the Tasks tab.
3. In the left navigation pane, under Application Solution Module, click Update ASM Recovery Partition.

4. Click the Apply button to begin the installation of the new image.

   Note
   Loading and installing the new image can take up to 10 minutes.

5. Wait for the following message to be displayed:

   Panel
   borderStyle none
   Caption 0 Figure 1 Image Installation Complete

    

    

6. Remove the USB flash drive from the system.

...