Page History

...

This technical guide shows how to configure the SBC Edge with a Tenor AF/AX for fax connection.

This document provides basic guidelines, and assumes the user has a working knowledge of the following products:

• The SBC 1000/2000
• Tenor AFM200

Deployed software versions in this document are:

...

Basic configuration information for these products can be found in the Best Practices section. 

Configure

...

the 

Spacevars
0 product

 (SBC)

...

Perform the steps below to configure the SBC 1000/2000 for the interconnection scenario.

Use the SBC 1000 web interface and search for the objects below to help with navigation.

...

SIP Registrar Table

1. Create an SBC 1000/2000 SIP Registrar table so the Tenor can register each of its analog ports as a SIP User Agent into the SBC 1000/2000.
2. Enter as many number of Users as expected analog ports to be registered:

...

1. Create the Tenor SIP Signaling Group which allows the SBC 1000/2000 to send and receive SIP calls to/from the Tenor with the following parameters (created previously).
2. Verify that the values in the Port and Protocol fields in the Listen Ports panel configured for the Tenor are the same when configuring the SBC1000/2000.
   

...

Create a dedicated transformation table to be able to receive a fax on the SBC 1000 and forward it to the Tenor, depending on the fax numbers to be routed from the SBC 1000 to Tenor.

...

Verify the fax section of the IP Routing Group menu is configured as shown below, and matches what was created on the SBC 1000/2000 for the T.38 codec:

...

These tables only look for and can adapt the called number in the above example, but you can also adapt the calling number.