Page History

...

This operation is used to configure the IP settings for the Application Solution Module (ASM). The SBC supports two ASM network adapters. Each adapter can be configured with IP settings, such as an IP address and DNS address (Network Adapter 2 is optional).  This is an essential requirement in order to ensure that the Sonus SBC 1000/2000 Communication Service becomes operational.

Caption
0 Figure 1 IPv4/IPv6 Addressing Supported per Network Adapter
Adapter IPv4 alone IPv6 alone IPv4 and IPv6 (both supported) SBC 1000/2000 Ethernet Port Designation Network Adapter 1 SBC 1000/2000. Ethernet Port 1 used by the ASM requires an IPv4 address; configuring an additional IPv6 address is optional. Network Adapter 2 SBC 1000. Ethernet Port 2 or 3 does not require IPv4; this port can be configured with IPv4 and/or IPv6. SBC 2000. Ethernet Port 2, 3, or 4 does not require IPv4; this port can be configured with IPv4 and/or IPv6.

...

1. In the WebUI, click the Settings tab.
   
   

2. In the left navigation pane, go to Application Solution Module > ASM Configuration.

   Panel
   borderStyle none
   Caption 0 Figure 1 ASM Configuration Image Modified

    

    
3. Select No from the DHCPv4 Enabled menu.
   
   
4. Enter the required IP settings. For field definitions, see ASM Configuration - Field Definitions.
   
   A "Current Activity Status" status window displays the progressof the change; this operation typically takes a few seconds.

...

1. In the WebUI, click the Settings tab.
   
   

2. In the left navigation pane, go to Application Solution Module > ASM Configuration. For field definitions, see ASM Configuration - Field Definitions.
   
   The example below shows DHCP disabled for IPv4 on Network Adapter 1 and enabled for IPv4 on Network Adapter 2.

   Panel
   borderStyle none
   Caption 0 Figure 1 Network Adapter 1 ASM Configuration - DHCP Enabled Image Modified

3. From DHCPv4 Enabled, select Yes. Depending on the IP Addressing mode selected, IPv4 and/or IPv6 options are displayed. See below:

   Caption
   0 Figure 1 DHCPv4 Enabled, Configuration Options
   Network Adapter 1 DHCPv4 Enabled IP Addressing Mode Configuration Options Available Yes IPv4 None Yes IPv4 and IPv6 IPv6 Configuration Network Adapter 2 DHCPv4 Enabled IP Addressing Mode  Configuration Options Available Yes IPv6  IPv6 Configuration Yes IPv4  None Yes IPv4 and IPv6  IPv6 Configuration

4. Update configuration (see Network Adapter 1 Configuration - Field Definitions and Network Adapter 2 Configuration - Field Definitions.
5. Click Apply.

...