Page History

...

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Tone Tables.

3. Add a Tone Profile Table (SIPtrunking: Tone Table) as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Add Tone Profile Table Image Modified

Media Profiles

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Media > Media Profiles.
3. Add two new Voice Codec Profiles, as shown below.
   1. Name them SIPtrunking: G.711 A-Law Voice and SIPtrunking: G.711 Mu-Law Voice.
   2. Select the G.711 A-Law Codec.

Media List

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Media > Media List.
3. Add a new Media List.
   1. Specify the Media Profiles created in the previous section in the Media Profiles List text box.

Note that in this example, the other variants in the Media List entry are left with their default settings (i.e: Crypto as NONE, Dead Call Detection as Disabled, Silence Suppression as Enabled,...etc.)

SIP Server Tables

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to SIP > SIP Server Tables.
3. Add two new SIP Server Table entries(one for each border element).
   1. Name them SIPtrunking: IP-PBX-1 and SIPtrunking: IP-PBX-2.

4. Configure the new entries from the previous step as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Add New SIP Server Table Entries Image Modified

SIP Profile

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to SIP > SIP Profiles.
3. Add a new SIP Profile as shown below.

4. Name it SIPtrunking: SIP Profile.

   Panel
   borderStyle none
   Caption 0 Figure 1 SIP Profile Table Image Modified

Transformation Table

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Transformation.
3. Add two new entries and name them SIPtrunking: Translation for IP-PBX-1 ext. and SIPtrunking: Translation for IP-PBX-2 ext..

4. Configure the entries created in the previous step as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Transformation Table Image Modified

Call Routing Table

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Call Routing Table.
3. Add two new Call Routing Tables, and name them SIPtrunking: to IP-PBX-1 and SIPtrunking: to IP-PBX-2.

...

Once the above configuration steps have been completed, a SIP call from Border Element 1 (IP-PBX-1) to Border Element 2 (IP-PBX-2) using Sonus SBC 1000/2000 SIP Trunking will have the following call flow: