| Workflow approval customer doc |
|---|
| approvers | radichkd |
|---|
| smes | gezerh |
|---|
|
| |
This section describes the steps for inserting and removing
Interface Cards from the rear of the Sonus SBC 1000/2000 chassis.
| Wiki Markup |
|---|
{multi-excerpt-include:pageTitle=_BoilerPlate|name=hw-service-warning|nopanel=true} |
...
| Wiki Markup |
|---|
{multi-excerpt-include:pageTitle=_BoilerPlate|name=warn-icard-hotswap|nopanel=true} |
| Multiexcerpt |
|---|
|
To Insert an Interface Card- Carefully insert the card so that the left and right edges slide into the mounting slots.
- Grip the outside of the attachment levers and push toward the inside of the card until the card locks into place.
 The red buttons click and pop out when the card is properly locked into place. - Tighten the screws on the right and left side of the interface card.
| Panel |
|---|
| bgColor | #FFFFFF |
|---|
| borderStyle | none |
|---|
| | Caption |
|---|
| 
|
|
| Panel |
|---|
| bgColor | #FFFFFF |
|---|
| borderStyle | none |
|---|
| | Caption |
|---|
| 0 | Figure |
|---|
| 1 | Lock Card in Place |
|---|
| 
|
|
|