Versions Compared

Old Version 6

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 7

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To create or modify an existing ISDN Signaling Group: Excerpt IncludeManaging ISDN Signaling GroupsManaging ISDN Signaling Groupsnopaneltrue

  1. Click the expand (Image Added) icon next to the entry you wish to modify.
  2. Edit the entry properties as required.

Modifying an ISDN Signaling Group Include Page_Modify_Entry_Modify_Entrynopaneltrue

  1. Click the expand (Image Added) icon next to the entry you wish to modify.
  2. Edit the entry properties as required.

BRI vs. PRI (T1) Ports

There is a subtle but very important difference in the UI between ISDN/BRI Signaling Groups and ISDN/PRI Signaling Groups. These differences appear in the Port and Protocol panels.

Caption
0Figure
1Port and Protocol

...

  1. From the Create Signaling Group drop down box at the top of the Signaling Group Table, select ISDN Signaling Group.

    Panel
    borderStylenone

    Caption
    0Figure
    1Create ISDN Signaling Group

    pagebreak 

    Anchor
    properties
    properties

...

Port and Protocol - Field Definitions

...

Panel
titleJump to Field Definition
Table of Contents
maxLevel4
minLevel4

Port Name

Panel
bgColor#FAFAFA
borderStylenone

Specifies the physical T1/E1 port used for this Signaling Group.

...

Specifies to which channels the Signaling Group is applied if the port is fractional.

Caption
0Figure
1Channel List Selection

pagebreak 

Switch Variant

Panel
bgColor#FAFAFA
borderStylenone

Specifies the ISDN variant for this signaling group.

...

Panel
bgColor#FAFAFA
borderStylenone

Specifies the TEI to assign for BRI when set to user side. 0 through 63 are absolute values to assign. If signaling group is PRI or network side BRI this parameter is not used. This field is available only when the TEI Assignment Type is set to Static.

Note
  The value of 0 for Static TEI is valid only for NTT. Other BRI specifications allow a value of 0 through 63 for Static TEI.

pagebreak 

Send Calling Name

Panel
bgColor#FAFAFA
borderStylenone

Specifies whether or not the Q.931 SETUP message is sent to the far-end should include the DISPLAY Information Element (IE).
Available only when ISDN Side is set to User and the Switch Variant is set to NI2 or Euro-ISDN.

If this option is enabled, the DISPLAY IE is populated for NI2 or Euro-ISDN switch types, otherwise the DISPLAY IE is not populated for these switch types.

In general, the DISPLAY IE is populated according to ISDN communication standards. The NI2 and Euro-ISDN specifications state that the DISPLAY IE should not be populated. This option allows you to override that configuration for your environment.

...

Panel
bgColor#FAFAFA
borderStylenone

Specifies whether or not to include the Network Facility Extension and Interpretation APDU in ASN.1 for QSIG. All QSIG specific ISDN Signaling groups must be configured the same system-wide for this field.

 pagebreak

Channels and Routing - Field Definitions

...

Panel
bgColor#FAFAFA
borderStylenone

In the event of a "No Channel/Circuit available" release cause code, the specified cause code will be sent to the relevant protocol module. For more information see the list of Cause Codes.

NOTE: This attribute relates only to Inbound calls on the Signaling Group where applied.

pagebreak 

Play Inband Message post-disconnect

...