Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. In the WebUI, click the Settings tab.
  2. In the left navigation pane, go to Signaling Groups > (relevant SIP Signaling Group).
  3. Change the Listening Ports configuration to 5068, as shown below.
  4. Change the TLS Profile ID to N/A.

...

Panel
borderStylenone

Caption
0Figure
1SIP Signaling Group Before

Image Modified

Panel
borderStylenone

Caption
0Figure
1SIP Signaling Group After

Image Modified

 

 

Media List

  1. In the WebUI, click the Settings tab.
  2. In the left navigation pane, go to Media > Media List > (relevant media list entry).
    (info) This is the Media List specified in the SIP Signaling Group above.
  3. Change the Crypto Profile ID value to None as shown below.

Panel
borderStylenone

Caption
0Figure
1Media List Before

Image Modified

Panel

...

borderStyle

...

none

Caption
0Figure
1Media List After

Image Modified

 

SIP Server Table

  1. In the WebUI, click the Settings tab.
  2. In the left navigation pane, go to SIP > SIP Server Tables >(relevant SIP Server Table Entry).
  3. Change the Port value to 5068, as shown below.
  4. Change the Protocol value to TCP, as shown below.

Panel
borderStylenone

Caption
0Figure
1SIP Server Table Before

Image Modified

Panel

...

borderStyle

...

none

Caption
0Figure
1SIP Server Table After

Image Modified

...

 

Lync Changes (Topology Builder)

...

  1. Log into the Lync front end server PC.
  2. Launch the Lync Server 2010 Topology Builder.
  3. In the Navigation Tree, go to Branch Sites > PSTN gateways > (relevant Sonus SBC 1000/2000 entry).
  4. Right-click the relevant Sonus SBC 1000/2000.
  5. Select Edit Properties...
  6. Change the Listening Port for IP/PSTN gateway to 5068, as shown below.
  7. Change the SIP Transport Protocol to TCP, as shown below.
  8. Click OK.

    Panel
    borderStylenone

    Caption
    0Figure
    1PSTN Gateway Properties Change

    Image Modified

Publish Topology

To publish the topology:

  1. In the Topology Builder navigation tree, right-click Lync Server 2010.
  2. Select Publish Topology....

    Panel
    borderStylenone

    Caption
    0Figure
    1Publish Topology

    Image Modified

Lync Mediation Server Service Restart

  1. Launch the Lync Server 2010 Configurationpage
    1. In your brorwser, go to (the FQDN of the front end pool//cscp).
  2. Select the *Mediation Server in the Service list.
  3. Select Stop service from the Action drop-down list, as shown below.
  4. Select Start service from the Actiondrop-down list, as shown below.

    Panel
    borderStylenone

    Caption
    0Figure
    1Lync Mediation Server Service Restart

    Image Modified

     

 

  1.