Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1ghoppe
REV5ghoppe
REV6ghoppe
REV3jasonwdbiziak
REV1allenm

Panel

In this section:

Table of Contents
maxLevel4

This section describes

Spacevars
0product
hardware and software requirements and recommendations for
Spacevars
0series3
installations using VMware ESXi.

 

Warning
iconfalse

The recommended hardware and software settings are intended to ensure optimum 

Spacevars
0product
stability and performance. If the recommended settings are not used, 
Spacevars
0product
system may not behave as expected.

License Requirements

You must obtain and apply a valid 

Spacevars
0product3
 license in order to configure and use the 
Spacevars
0product3
. See the instructions at Obtaining and Installing a SWe Lite Trial License.

Server Hardware Requirements

Caption
0Table
1Hardware Requirements
ConfigurationRequirement
Processor2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later)
Host OSESXi 5.5 or above
Architecture64-bit Intel processor
RAMRAM requirements are dependent upon the number of VMs hosted, the memory assigned to each VM instance, and the relative overhead memory associated with each.
DatastoreHard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether snapshots will be enabled.

Warning
iconfalse

Platforms using AMD processors are not supported.

 

Minimum ESXi hosting requirements are posted by VMware.

VMware ESXi

Customized ESXi images for various server platforms are available on VMware and Hardware platform vendor sites.

  • It ensures that all the required drivers for network and storage controllers are available to run ESXi server.
  • Most of the customized ESXi images comes with customized management software to manage server running ESXi software.
  • Customized ESXi images for HP ProLiant and IBM servers are available at:

For more information, please visit the VMware Knowledge Base

Refer to VMware Compatibility Guide (external site) for a list of VMware supported Intel processors. 

Refer to ESXi hardware requirements to ensure the VMware supported Intel processors meet ESXi hardware requirements.

Sonus Recommendations for SBC SWe Lite

General Recommendations

  • Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on the server platform, including resources needed by ESXi itself.
  • Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.
  • Disconnect or disable any physical hardware devices that you will not be using (floppy drives, network interfaces, storage controllers, optical drives, USB controllers, etc.) under BIOS settings to free up interrupt/CPU resources.

 

Caption
0Table
1VM Configuration Recommendations
SettingMinimum
vCPU1
RAM1 GB
vNIC

5

(Up to 3 may be disabled, if only a single vNIC is required for media. Note: One vNIC is mandatory for management)

Virtual Hard Disk5 GB
 

Additional Information

  • The SBC SWeLite VM does not currently support allocation of more than one vCPU.
  • With minimum RAM allocation, the maximum SIP endpoint registrars is 1000, and the maximum number of concurrent calls is 100.
  • The estimated ESXi overhead memory for each SBC SWe Lite Virtual Machine is 30MB.
  • Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
  • Each SBC SWeLite VM will use approximately 5GB of Virtual Hard Drive space. Drive size is predetermined by the imported image.

 

Info
iconfalse

Refer to Downloading the SBC SWe Lite Package for software download instructions.

Pagebreak