Use this object to remove an entry (by it's IP address) from the list of Enhanced DBL entries.
On the SBC main screen, navigate to All > Address Context > Enhanced DBL > Remove Enhanced DBL Entry.
The Remove Enhanced DBL Entry window is displayed.
Select the Address Context from the dropdown list.
Caption |
---|
0 | Figure |
---|
1 | Address Context - dropdown |
---|
|
|
The Commands dropdown list is displayed. Select the Remove IP Entry
command from the dropdown list.
Caption |
---|
0 | Figure |
---|
1 | Commands - dropdown list |
---|
|
|
Info |
---|
|
By default, the only available command is Remove IP Entry . |
The removeIpEntry pop-up window is displayed.
Caption |
---|
0 | Figure |
---|
1 | Remove IP Entry window |
---|
|
|
The parameters and their descriptions are given in the table below:
Caption |
---|
0 | Table |
---|
1 | Remove IP Entry - parameter description |
---|
|
Parameter | Description |
---|
Source IP Address | The source IP address (IPv4/IPv6 ) of the the enhanced DBL entry. | Source Port | The port (0-65535 ) used by the source IP address. The default value is 0. Note: A value of "0" means no port is used. | Transport | The transport protocol used. The following options are available in the drop-down list: None (default)SCTP TCP TLS-TCP UDP
|
|
Make necessary changes and click the removeIpEntry button. On saving the changes successfully, a confirmation message is displayed.
Caption |
---|
0 | Figure |
---|
1 | Remove IP Entry - confirmation |
---|
|
|
Click OK to complete the removal process.