Page History

 

This section provides information on the 

Spacevars
0 model5

package content and required tools to rack mount the SBC platform.

Required Tools

Before you install the

Spacevars
0 model5

chassis into a rack, make sure that you have the following tools and equipment:

• #2 Phillips screwdriver (to install brackets and the chassis)
• 7/16" (11 mm) wrench (to attach earth ground lug)
• Label maker (to label cables, if needed)
• Voltmeter (for installing units with DC power supplies)
• A marker or masking tape to mark mounting holes

Spacevars
0 model5

Package Content

Before you install a new 

Spacevars
0 model5

chassis, unpack and inspect your equipment and hardware to verify that you have all the necessary items to install your 

Spacevars
0 model5

chassis.

Accessory Kit

The following table provides the list of Bill of Materials (BOMs) provided with the 

Spacevars
0 model5

Accessory Kit.

Caption
0 Table 1 BOM Details
Item Number Item Description Qty 301-30016 LUG 2 HOLE ,#6 AWG WIRE, 45° ANGLE TONGUE, 1/4" STUD HOLE, 5/8" HOLE SPACING 1 301-31254 SFP DUST PLUG 6 401-00119 CABLE, 9 POS DSUB M-F NULL, MOULDED- 3M.-ROHS 1 510-00038 ESD WRIST STRAP 1 510-00056 WASHER, 1/4 SPLIT LOCK STLS STL-ROHS 2 510-00057 WASHER, FLAT- 1/4 REG STLS STL-ROHS 2 511-00046 NUT, HEX 1/4-20 STL STEEL-ROHS 2

Note
Carefully remove the contents from the shipping container, and check each item for damage. The  Spacevars 0 model5 is shipped with the items listed below. If any item is missing or damaged, contact your Sonus representative for support.

Universal Rack Mount Kit

The following items are included in each Universal Rack Mount Kit:

 The following figure describes the Universal Rack Mount Kit contents.

Caption
0 Figure 1 Universal Rack Mount Kit