Versions Compared

Old Version 5

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

 

The

Spacevars
0product
 sends Device Watchdog Requests based on the configured Device Watchdog Timer value. Device Watchdog Timer is started once the transport connection towards a Diameter Peer is established. It is reset whenever any Diameter Message is received from the Diameter Peer. It can be a Device Watchdog Answer, some other Diameter Base Protocol Message, or any message from any of the Diameter Application (for example, Rx interface AAA messages).

Code Block
languagenone
set addressContext default diamNode rxNode primaryOriginHost <SBC.primary.origin.host> secondaryOriginHost <SBC.secondary.origin.host> ipInterfaceGroupName <Ip.InterfaceGroup.Name> ipV4Address <diamNode.IPV4.Address> ipV6Address <diamNode.IPV4.Address> originRealm <SBC.origin.realm> transactionTimeout 6000
set addressContext default diamNode rxNode state enabled
set addressContext default diamNode rxNode peer <Diam.Peer.Name> ipAddress <Diam.Peer.IpAddress> tcpPort <Diam.Peer.Port> fqdn <Peer.Fqdn>
set addressContext default diamNode rxNode peer <Diam.Peer.Name> deviceWatchdogTimer 1000
set addressContext default diamNode rxNode peer <Diam.Peer.Name> deviceWatchdogTimerAnswerTimeout 2000
set addressContext default diamNode rxNode peer <Diam.Peer.Name> state enabled
set addressContext default diamNode rxNode realmRoute <Pcrf.realm.RouteName> realm <Pcrf.realm.Name> peer <Diam.Peer.Name> appId rx priority 0
set addressContext default diamNode rxNode realmRoute <Pcrf.realm.RouteName> state enabled 
set addressContext default staticRoute <Diam.Peer.IpAddress> <Subnet.Mask> <Defaul.Gateway> <Ip.InterfaceGroup.Name> <Ip.Interface> preference 100
commit

Pagebreak