Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Specifies the NFCI Default values.

To View and Edit Nfci Default Values

On SBC main screen, go to Configuration > Profile Management > Category: Signaling Profiles > Signaling Profile > Egress >Uk Isup > Nfci Default Values.

Select the desired Signaling Profile from the drop-down list to view its respective Nfci Default Values parameters.

The Nfci Default Values window is displayed.

Caption
0Figure
1Signaling Profiles - Signaling Profile - Egrees - Nfci Default Values

The following fields are displayed:

Caption
0Table
1Signaling Profile - Egress - Nfci Default Values parameters
ParameterDescription
Cli Blocking Available

When interworking a non-UK ISUP variant to UK ISUP- If selected, the CLI Blocking Available bit is set in the NFCI (National Forward Call Indicators) parameter of the outgoing UK ISUP IAM. For a UK ISUP to UK ISUP route? If selected, the CLI Blocking Available bit is set in the NFCI parameter of the outgoing UK ISUP IAM. The options are:

  • disable (default)
  • enable

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.