applies disconnect treatment to the ingress party specified by the Signaling Sequence Profile (SSP). This SSP is derived from the SCP disconnect treatment profile (DTP) and disconnect treatment indicator provided by the PSX in a trigger response.
The DTP must be explicitly configured on the
. The existing disconnect reason is still forwarded to the ingress party immediately after the disconnect treatment (if applicable) is applied. The disconnect reason can be SCP or egress party initiated.
To View Disconnect Signal Sequence Profile
On SBC main screen, go to Configuration > Profile Management > Category: Service Profiles >Disconnect Signal Sequence Profile.
The Disconnect Signal Sequence Profile window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile |
|---|
|
|
To Edit Disconnect Signal Sequence Profile
To edit any of the Disconnect Signal Sequence Profile in the list, click the radio button next to the specific Disconnect Signal Sequence Profile name.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile Highlighted |
|---|
|
|
The Edit Selected Disconnect Signal Sequence Profile window is displayed below.
You would not be able to edit as the field is read-only.
To Create Disconnect Signal Sequence Profile
To create a new Disconnect Signal Sequence Profile, click New Disconnect Signal Sequence Profile tab on the Disconnect Signal Sequence Profile List panel.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile Fields |
|---|
|
|
The Create New Disconnect Signal Sequence Profile window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile Create Window |
|---|
|
|
The following fields are displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Disconnect Signal Sequence Profile Parameters |
|---|
|
| Parameter | Description |
|---|
Name | Specifies the user name for this Disconnect Signal Sequence Profile. |
|
To Delete Disconnect Signal Sequence Profile
To delete any of the created Disconnect Signal Sequence Profile, click the radio button next to the specific Disconnect Signal Sequence Profile which you want to delete.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile Highlighted |
|---|
|
|
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Service Profiles - Disconnect Signal Sequence Profile Delete Confirmation |
|---|
|
|
Click Yes to remove the specific Disconnect Signal Sequence Profile from the list.