Use this object to specify the packet outage detection parameters for this SIP trunk group.
To View and Edit Packet Outage
On the
main screen, go to
Configuration >
System Provisioning >
Category: Trunk Provisioning >
Trunk Group >
Sip Trunk Group >
Sip Trunk Advanced >
Packet Outage. The Packet Outage window is displayed.
The Packet Outage can be checked for each Address Context, for each Zone, for each Sip Trunk Group created or for all the Address Contexts, Zones and Sip Trunk Groups created. Use the drop-down box to select the desired Address Context, Zone and Sip Trunk Group.
The Edit Packet Outage window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Sip Trunk Advanced - Packet Outage Edit Window |
|---|
|
|
The following fields are displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | H323 Trunk Advanced - Packet Outage Parameters |
|---|
|
Parameter
|
Description
|
|---|
Minimum Duration | Specifies the period of outage for a call, in milliseconds, for that call to be counted as part of the packet outage detection algorithm. Must be 0-65535, default is 6000 (milliseconds). | Minimum Calls | Specifies, for the current interval, the number of calls with outages that are required to declare a packet outage event. Must be 0-65535, default is 1000 (calls). | Bandwidth Limit Reduction | Specifies the amount to reduce the bandwidth limit (as a percentage of the configured limit) when a packet outage is detected. Must be 0-100, default is 50 (percent). | Detection State
| Specifies the administrative state of packet outage detection: enabled—automatic bandwidth reduction will occur when a packet outage is detected.disabled (default)—packet outages are not detected and the maximum bandwidth limit is restored.
| Detection Interval
| Specifies the time interval, in minutes, for detecting packet outages via the packet outage detection algorithm. Must be 5- 1440, default is 15 (minutes). |
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
Packet Outage Commands
To clear all the Trunk Group Packet detection, choose Clear in Commands drop- down box and click Select.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Sip Trunk Advanced - Packet Outage Commands |
|---|
|
|
A pop-up window appears seeking your confirmation. Click Clear.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | SIP Trunk Advanced - Packet Outage Command Confirm |
|---|
|
|
A confirmation message appears with the result of this action.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | SIP Trunk Advanced - Packet outage Reason |
|---|
|
|
Click OK to complete the process and exit.