Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel

In this section:

Table of Contents
maxLevel3

This section specifies the carrier information parameters

To View and Edit Carrier Information

On SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Ip Signaling Profile > Ingress Ip Attributes > Carrier Information. The Carrier Information window is displayed.

DEFAULT_H323

On the Carrier Information window, choose the Ip Signaling Profile as DEFAULT_H323 to view the Carrier Information for H323 Trunk Group.

Caption
0Figure
1Trunk Provisioning - Ingress Ip Attributes - Carrier Information

There are no Carrier Information parameters for DEFAULT_H323 type of Ingress Ip Attributes.

DEFAULT_SIP

On the Carrier Information window, choose the Ip Signaling Profile as DEFAULT_SIP to view the Carrier Information parameters for SIP Trunk Group.

Caption
0Figure
1Trunk Provisioning - Ingress Ip Attributes - Carrier Information

The following fields are displayed:

Caption
0Table
1Ingress Ip Attributes - Carrier Information

Parameter

Description

Generate Terminating Ca

Use this flag on the ingress SIP side to decide whether to interwork the terminating CA data from ISUP to SIP 18x messages. When enabled, the SBC maps the terminating CA data from ISUP to SIP 18x messages. When disabled, the SBCdoes not map the terminating CA data from ISUP to SIP 18x messages. The options are:

  • disable (default)
  • enable
Generate Terminating Cic

Use this flag on the ingress SIP side to decide whether to interwork the terminating CIC data from ISUP to SIP 18x messages. When enabled, the SBC maps the terminating CIC data from ISUP to SIP 18x messages. When disabled, the SBCdoes not map the terminating CIC data from ISUP to SIP 18x messages. The options are:

  • disable (default)
  • enable

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.