Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel

In this section:

Table of Contents
maxLevel2

 

This object allows you to configure a profile defining conditions for triggering on DTMF digit strings. For additional DTMF details, refer to DTMF and RTP Relay.

Info

Refer to Digit Profile - CLI to configure a Digit Profile defining frequency ranges, pulse durations, power levels, etc. for DTMF, MFR1 and MFR2 digit detection and generation.

Command Syntax

Code Block
languagenone
 % set profiles dtmfTrigger <egress | ingress> 
	interdigitTimeout <0-65535> 
	longdigitDuration <0-65535> 
	pattern <trigger pattern> 
	state <disabled | enabled>

Command Parameters

The DTMF Trigger Parameters are as shown below:

Caption
0Table
1DTMF Trigger Parameters

Parameter

Length/Range

Description

dtmfTrigger

N/A

<egress | ingress> – Choose whether this is an ingress or egress DTMF Trigger profile.

interdigitTimeout

0-65535

Specifies inter-digit timer in milliseconds. If set to "0", this timer is disabled. Enter value in range of 0-65535 in milliseconds. (default = 4000)

longdigitDuration

0-65535

Specifies minimum duration in milliseconds for a digit to be considered long. If set to "0", this timer is disabled. Enter value in range of 0-65535 in milliseconds. (default = 2000).

pattern

N/A

Use this parameter to define the trigger pattern.

state

N/A

Administrative state of this DTMF trigger.

  • disabled (default)
  • enabled

Command Example

Code Block
languagenone
 
% show profiles dtmfTrigger  
	dtmfTrigger egress {  
		state enabled;  
		pattern 3;  
		interdigitTimeout 5000;  
		longdigitDuration 2000;  
	}  
	dtmfTrigger ingress {  
		state enabled;  
		pattern 4;  
		interdigitTimeout 3000;  
		longdigitDuration 4000;  
	}