Page History

...

1. Launch the host remote console through the BMC. Refer to Launching the SBC 5400 BMC Remote Console.

   Caption
   0 Figure 1 SBC 5400 JViewer window

2. Select Media in the JViewer and click Virtual Media Wizard. The Virtual Media screen appears.

   Caption
   0 Figure 1 JViewer - Virtual Media Wizard option

3. Select ISO Image from CD/DVD Media1 section of the screen.

   Caption
   0 Figure 1 SBC 5400 CD-DVD Media1 option

4. Click Browse. From the Open dialog, browse to and select the connexip-os_<version>_amd64.iso file and click Open.

   Caption
   0 Figure 1 SBC 5400 ConnexIP ISO file

5. Click Connect CD/DVD. A message Device redirected in Read Only Mode appears on the screen. Click OK to continue. This mounts the ISO image from your local desktop or laptop.

   Caption
   0 Figure 1 SBC 5400 ConnexIP Device Redirection message

6. Click Close to exit the window.

7. In the JViewer window, execute the following command to reboot the system:

   Code Block
   language none
   # reboot

8. After few minutes, the splash screen appears. Press <Del> or <Esc> key immediately to enter into BIOS configuration screen.

   Caption
   0 Figure 1 SBC 5400 ConnexIP Install screen 1

9. The BIOS setup utility screen is displayed. Use the left arrow key to navigate to the Save & Exit menu.

   Caption
   0 Figure 1 SBC 5400 ConnexIP Install screen 2

10. Select AMI Virtual CDROM0 1.00 from Save & Exit menu to boot from the virtual CD drive. This instructs the server to boot from the redirected ConnexIP OS ISO image.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 3

11. By default. the Install option is selected. Press <Enter> to start the installation.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 4

12. Select the <Language> and press Enter. By default, American English is selected.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 5

    
    The automated ConnexIP OS installation process starts. This process takes approximately 30 to 40 minutes to complete.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 6

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 7

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 8

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 9

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 10

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 11

    
    Once the installation is completed, the disk partition upgrade process starts. At this stage, DO NOT power off the system.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 12

    
    After system reboot, the ConnexIP login screen appears on the screen. This marks the completion of the ConnexIP OS Installation process.

    Caption
    0 Figure 1 SBC 5400 ConnexIP Install screen 13

    
    Close the JViewer window.

...