...
...
The following summary outlines the key steps required to install SBC SWe on on KVM Hypervisor and perform an initial configuration on the system.
...
| Excerpt |
|---|
Below is a summary of key steps needed to get your up and ready for provisioning. 
| Create an IP planAn IP Plan helps you to gather configuration details, such as the IP addresses the management port, HA port and two media ports for Virtual Machine (VM). The media ports are used for SIP and RTP traffic.For help with completing an IP Plan, see refer to Creating IP Plan for SBC SWe . . |
| Create Network BridgeCreate the required network bridges for the VM instance, see refer to Creating Network Bridge. |
| Create a VM for This step involves creating a VM and allocating resources, and configuring a datastore to contain the Operating System (OS) and Application software. See Refer to Creating a New SBC SWe Instance on KVM Hypervisor for details. |
Image Modified | Install OS and ApplicationPerform this action after creating a VM to install | SBC | OS on the VM instance and install application software through Embedded Management Application (EMA). | See, Refer to Installing SBC Application on KVM Hypervisor for details. | | Install License FileInstall SBC licenses using the EMA. See Refer to System Administration - License Management and Managing SBC Licenses for details. |
| You are now ready to configure your for traffic!A large amount of information is needed to configure your platform. Use the Creating a SBC SWe IP Plan page to help manage this information. If you would like to set up a basic call flow to test your configuration, see refer to How to Set up a Basic Call Flow. |
|