Page History

Re Key Confd Encryption Key

Specifies that it causes encryption keys used by the system configuration database to be regenerated.

Note: Sonus recommends backing up current encrypted parameters in plaintext, if possible.  Sonus further recommends performing a full configuration backup immediately after this activity has successfully completed.

Remove Saved Config


Remove the saved configuration from the system.

• fileName – Specify filename of configuration to remove from the system.

Use this action command to configure SBC for Geographical Redundancy High Availability (GRHA) mode when active and standby servers are located in two different data centers to protect SBCs against data center and network failures. To configure/change just one setting, use currentValue option for the other setting.

• bondMonitoring – Select the bond monitoring type for GRHA mode.
  • currentValue 
  • direct-connect
  • network-connect
• leaderElection – Select the leader election algorithm type to use for GRHA mode.
  • currentValue 
  • enhanced
  • standard

Refer to:

• Refer to SBC Redundancy for feature details.
• Refer to Show Table System or Show Status System for statistics details
• Refer to Enabling SBC Core Geographical Redundancy HA Mode best practice for configuration details.

Use this command to verify that the SBC policy and configuration databases on the active server are in sync and that the policy databases on the active and standby servers are in sync. Because these commands take a few seconds to execute, it is not advisable to constantly run these commands on systems.

• activeAndStandbyPolicy – Check if policy databases on the active and standby servers are in sync.
• activeConfigAndActivePolicy – Check if the policy and configuration databases on the active server are in sync.
• all – Perform both of the above checks.

Zeroize Persistent Keys


Use this control to securely erase all persistent CSPs from the system. The  SBC server reboots after confirmation.