Page History

...

...

1. If the application is running, gracefully shut down the application.
2. Remove power from the chassis.
3. Remove the bezel from the front panel of the chassis using the procedure on the page SBC 5400 Bezel.
4. Attach an Electrostatic Discharge wrist strap to the ESD grounding point on the front rear panel of the chassis, and place the other end around your wrist (see Connecting ESD Wrist Strap for details).

5. Use a #2 Phillips screwdriver to loosen the 2 captive screw screws (a spring-loaded screw that does not detach from the device) securing the lever tray of the SSD being replaced as shown below.

   Caption
   0 Figure 1 Replacing Removing the SSD
   Image RemovedImage Added

6. Pull the lever captive screws until the SSD disengages from the

   Spacevars
   0 seriesmodel5

   chassis.
   NoteInsert the new SSD into the same slot that previously contained

   Caption
   0 Figure 1 Pulling the SSD
   Image Added

   the old SSD.

7. Remove the SSD and place it into the ESD protective bag.

8. Remove the new SSD from the ESD bag and insert it fully into the empty SSD slot.

9. Close the lever and tighten Tighten the captive screw to 10 inch/lbs using the torque driver.

10. Reapply power to

    Spacevars
    0 model5

    chassis (refer to appropriate Power Supply CRU for guidance).

11. Verify that the SSD LED is Green (located to the right left of the SSD).

12. Unplug the ESD wrist strap from the front of the chassis.Reattach the bezel assembly to 

    Spacevars
    0 model5

    (see SBC 5400 Bezel). 

CRU Storage

...

• Temperature must be between -40C and +70C.

...