Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to Configuration

Back to Configuration - System Provisioning

Back to Category - SIP Carrier Peering

Back to SIP Carrier Peering - Sip Trunk Group

Back to SIP Carrier Peering: Sip Trunk Group - Signaling

Use this object to configure TCP Fallback settings.

...

On SBC main screen, go to Configuration > System Provisioning > Category: SIP Carrier Peering > Signaling > TCPFallback TCP Fallback. The TCPFallback TCP Fallback window is displayed.

The TCPFallback The TCP Fallback can be checked for each Address Context, for each Zone, for each Sip Trunk Group created or for all the Address Contexts, Zones and Sip Trunk Groups created. Use the drop-down box to select the desired Address Context, Zone and Sip Trunk Group.

The Edit TCPFallback Edit TCP Fallback window is displayed.

Caption
0Figure
1SIP Carrier Peering - Signaling - TCPFallbackTCP Fallback

The following fields are displayed:

Caption
0Table
1Sip Trunk Group - Signaling - TCPFallback TCP Fallback parameters

Parameter

Description

Max MTUSupported MTU Supported Over UDPControlUDP Control

 Maximum MTU Size accepted over UDP.

  • disabled (default)
  • enabled

Max MTUSupported MTU Supported Over UDPValueUDP Value

Maximum size of the SIP Invite accepted over UDP. The value ranges from 1 to 5000 and the default value is 1300.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

Include Page
TCP_Fallback_Behavior
TCP_Fallback_Behavior

Pagebreak