Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Log on to SBC BMC GUI using the IP address configured in one of the previous sections.

    note
    Info
    iconfalse
    titleNote

    Use any one of the following methods to obtain the BMC IP address:

    Configuring SBC 5400 BMC IP Address Via Serial Console

    Or

    Configuring SBC 5400 BMC for Remote Access 

    Code Block
    languagenone
    username: root
    password: superuser


    The BMC Main Screen appears:

    Caption
    0Figure
    1BMC Main Screen
     
  2. Click Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

    note
    Info
    iconfalse
    titleNote

    Refer to SBC 5400 Media Ports and Operational Modes to know more about these four media ports and their operational modes. 

    The SBC 5400 platform includes the following configurable media port configurations.

    note
    Caption
    0Figure
    1Platform Management Network Settings
     
    Info
    iconfalse
    titleNote

    A message appears to enter the management IP addresses for the first time installation. 

  3. If the management interfaces have not yet been configured, a warning message appears. Click OK to proceed with the Management Port configuration.

    Caption
    0Figure
    1Management Interfaces Not Configured Warning message
     
  4. Configure the following network settings for all the four management interfaces as needed:

    - IPv4 Address, Prefix and Default Gateway

    - IPv6 Address, Prefix and Default Gateway

     

    note
    Info
    iconfalse
    titleNote

    The IPv4 Address, Prefix and Default Gateway should be configured for Management Interface "0". For all other Management Interfaces, the settings are optional. 

    Caption
    0Figure
    1BMC Platform Management Network Settings Window
  5. Click Save.

    note
    Info
    iconfalse
    titleNote

    Once you save the changes to the Management IP addresses, a warning message appears. Note that the changes to the Management IP addresses will only take effect when the SBC application is Installed (or re-Installed if already present). Refer to SBC 5400 - Installing Application for more information. 

    Caption
    0Figure
    1BMC Warning Message
     
  6.  Click OK to complete the process.

...