Page History

...

In the mounting hardware bag provided with the Sonus SBC 2000 system, find the rear support brackets (2) and 9-inch extension arms (2).
If you are installing the Sonus SBC 2000 system into a 30-inch depth rack, attach the extension arms to the support brackets.
Attach the support brackets securely to the two rear posts of your equipment rack. Refer to the illustration below for visual details of the assembly:
Panel
bgColor #FFFFFF
borderStyle none
Caption
0 Figure
1 Assemble
And
and Install Rear Support Brackets
Image Modified

Note
The illustration above shows the rear bracket assembly for a rack with a 30-inch depth. For racks with a 24-inch depth, do not use the 9-inch extension arm and attach each support bracket directly to the rear rack posts.

...

Attach the 2 rack mounting ears securely to the front corners of the Sonus SBC 2000 chassis.
Attach the 2 pan handle plates securely to the rear corners of the Sonus SBC 2000 chassis.
Working with a partner, lift the Sonus SBC 2000 chassis and slide it into the equipment rack, making sure to seat each pan handle plate into the support brackets mounted on the rear support posts.
Attach the 2 rack mounting ears securely to the front mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).

Panel
bgColor #FFFFFF
borderStyle none
Caption
0 Figure
1 Install
In
in 4-Post Equipment Rack
Image Modified

Warning
Do not block the air vents on either side of the Sonus SBC 2000 chassis. Both sides of the unit must clear to ensure proper cooling of the unit.

...

Attach the 2 rack mounting ears securely to the center mounting points on both sides of the Sonus SBC 2000 chassis.
Attach the 2 rack mounting ears securely to the mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).

Panel
bgColor #FFFFFF
borderStyle none
Caption
0 Figure
1 Install
In
in 2-Post Equipment Rack
Image Modified

Installing Interface Cards

...

Place the cable management bracket on top of the pan handle plates.
Note
If you have installed the Sonus SBC 2000 chassis in a 2-post configuration, you must install the pan handle plates on the rear corners of the chassis.
Use the provided cable ties to secure the cable management bracket to the pan handle plates. Refer to the illustration below for visual details of the installation (click to enlarge).

Panel
bgColor #FFFFFF
borderStyle none
Caption
0 Figure
1 Install Cable Management Bracket
Image Modified

Warning
*DO NOT INSTALL EITHER Sonus or TELECOM CABLES. You must complete the Initial Configuration before* connecting the Sonus SBC 2000 system to your network.**

...