Page History

...

The Sonus SBC 1000 system must have the necessary licenses to make calls. In addition to CAS and DSP channels, and depending upon the types of calls, the Transcoding and SIP calls licenses may also be necessary as shown below:

FXS Card State and Port Status

...

• Check the state of the FXS card.

  • Verify that the state for the Telco Module(s) indicated in the Cards/Modules Status pane is Activated.

    Panel
    borderStyle none
    Caption 0 Figure 1 Cards/Modules Status Image Modified

Port Status

• Check the Port Status to verify that the FXS ports are functional.

  • Verify that the Admin State and Service Status for each port indicates Up as shown below.

    Panel
    borderStyle none
    Caption 0 Figure 1 Port Status Image Modified

FXS not Activated and Up? Did you upgrade the boot image and Sonus SBC 1000 base software versions as outlined above.

...

Verify that your FXS devices are connected to the ports you plan to configure.
Later in this article, you will create a CAS Signaling Group and assign channels and ports, they must match the physical ports to which the FXS devices are connected. See the figure below.

...

1. Create an FXS Signaling Profile for CAS.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create FXS Signaling Profile Image Modified

2. Create a CAS Signaling Group.
   Make sure to set the Channel Hunting to Own Number, otherwise the first free channel will answer every call (regardless of any other configuration settings).

   Panel
   borderStyle none
   Caption 0 Figure 1 Create CAS Signaling Group Image Modified

    

    

3. Create an Assigned Channel and apply the desired phone number to the corresponding FXS port.
   You may add all of the port/number combinations for FXS in a single Signaling Group.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Assigned Channel Image Modified

    

    

4. Verify that the CAS Signaling group is configured as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Configuration Of CAS Signaling Group Image Modified

    

    

5. Verify that the FXS-attached phone(s) now have dial-tone.

...

1. Create a Transformation Table for the FXS calls called PSTN to FXS:

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Transformation Table Image Modified

    

    

2. Create a Transformation entry to that table called PSTN to FXS Transformation.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Transformation Table Entry Image Modified

    

    

3. Add a call route table called From ISDN to SIP.

   Panel
   borderStyle none
   Caption 0 Figure 1 Add Call Route Table Image Modified

    

   Add a call route entry to that table which employs the transformation created in the previous step called PSTN to FXS.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Call Routing Entry Image Modified

    

    

4. Resequence the FXS call route.

    

   Panel
   borderStyle none
   Caption 0 Figure 1 Resequence FXS Call Route Image Modified Image Modified

Calls should now work from ISDN to FXS.

...