Page History

Excerpt IncludeNot_for_SWeNot_for_SWenopaneltrue 

This article describes the steps necessary to modify the Sonus SBC 1000/2000

For the purposes of this article it is assumed that PBX – Sonus SBC 1000/2000 – Microsoft Lync 2010 configuration is in place already with MTLS/SRTP as SIP Transport. 

The process requires changes on both the Sonus SBC 1000/2000 and on the Lync Server. The six steps to accomplish the change are:

1. Edit the appropriate Signal Group on the Sonus SBC 1000/2000.
2. Edit the appropriate Media List on the Sonus SBC 1000/2000.
3. Edit the appropriate SIP Server Table on the Sonus SBC 1000/2000.
4. Edit the port and protocol settings on the Lync Server.
5. Publish the altered topology
6. Stop/Restart the Lync Mediation Server service.

Topology Before

Topology After

...

SBC

...

Configuration Changes

SIP Signaling Group

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups > (relevant SIP Signaling Group).
3. Change the Listening Ports configuration to 5068, as shown below.

4. Change the TLS Profile ID to N/A.

Media List

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Media > Media List > (relevant media list entry).
   This is the Media List specified in the SIP Signaling Group above.

3. Change the Crypto Profile ID value to None as shown below.

SIP Server Table

...

Lync Changes (Topology Builder)

...

1. Log into the Lync front end server PC.
2. Launch the Lync Server 2010 Topology Builder.
3. In the Navigation Tree, go to Branch Sites > PSTN gateways > (relevant Sonus SBC 1000/2000 entry).
4. Right-click the relevant Sonus SBC 1000/2000.
5. Select Edit Properties...
6. Change the Listening Port for IP/PSTN gateway to 5068, as shown below.
7. Change the SIP Transport Protocol to TCP, as shown below.

8. Click OK.

   Panel
   borderStyle none
   Caption 0 Figure 1 PSTN Gateway Properties Change Image Modified

Publish Topology

...

1. In the Topology Builder navigation tree, right-click Lync Server 2010.

2. Select Publish Topology....

   Panel
   borderStyle none
   Caption 0 Figure 1 Publish Topology Image Modified

Lync Mediation Server Service Restart

1. Launch the Lync Server 2010 Configurationpage
   1. In your brorwser, go to (the FQDN of the front end pool//cscp).
2. Select the *Mediation Server in the Service list.
3. Select Stop service from the Action drop-down list, as shown below.

4. Select Start service from the Actiondrop-down list, as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Lync Mediation Server Service Restart Image Modified

   Pagebreak