Page History

This article describes the steps necessary to configure the Sonus SBC 1000/2000 with

...

• 2x Microsoft Lync 2010 front end servers
• 1x F5 Networks hardware load balancer
• 1x Meridian PBX1x Sonus SBC 1000/2000 Gateway
• 1x 

  Spacevars
  0 product

...

1. Using the DNS Manager, verify that the Lync 2010 Enterprise Pool Alias is pointing (therefore resolving) to the IP address of the hardware Load balancer machine as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 DNS Manager

2. Verify that the VLAN interface used to communicate with the Lync server is tagged as indicted below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Tag VLAN Interface

3. Verify that the F5 MGMT IP address is configured to use the VLAN interface set in the previous step.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Configuration of F5 MGMT IP Address

4. Verify that the VLAN interface Settings are configured as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Configuration of VLAN Interface Settings

5. Verify that Local Traffic > Nodes settings contain the Lync FE1, Lync FE2, and the virtual IP address of hardware load balancer machine as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Node Settings

6. Verify that the settings found in Local Traffic > Pools contain the pools that the F5 load balancer listens to Lync on defined port numbers for various services as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Pool Settings

    

   NOTE: the details of pool creation is explained in Deploying the BIG-IP LTM with Microsoft Lync Server 2010as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Details of Pool Creation

7. Verify the virtual server making use of the pools created above has itself been created as shown below.

   Panel
   borderStyle none
   Caption 0 Figure 1 Verify Virtual Server

Sonus SBC 2000 Configuration

Spacevars
0 product

 Configuration

The

• Federated IP/FQDN: Pool FQDN in the IP/FQDN field
• Netmask: 255.255.255.255 in the Netmask field
  
  These fields allow the Sonus SBC 1000/2000 to

  Spacevars
  0 product

   to receive SIP messages from the hardware load balancer HWLB. However, in order to receive/send SIP messages to/from Front End Servers, the Netmask field must be configured with a value of 255.255.255.0.
  
  

...

Using the Log Exchange utility, you can verify the F5 Hardware Load Balancer (HWLB) in action —

PSTN ph >

...

Spacevars
0 product

> Lync client

The deployment in this article allows the following call flow in PSTN ph > Sonus SBC 1000/2000 >

LYNC client >

...

Spacevars
0 product

 > PSTN ph

The deployment in this article allows the following call flow in Lync client > Sonus SBC 1000/2000 >

...